How To Install Rear View Mirror Dash Cam

Whereas the entrance digicam goes to the rear view mirror the rear digicam installs simply above the license plate. Simply make certain the sprint digicam lens will not be pointing by means of the dotted window tint on the prime of the windshield.

Set up Instruction Wi-fi Backup Digicam Sprint Digicam Backup Digicam

2Mounting the slicone rubber pad and clip onto the car rearview mirror.

Tips on how to set up rear view mirror sprint cam. 3Adjust the clip to suit one of the best angle. Conveniently select the view desired. It is advisable disassemble the adapter and join the corresponding wires in it to energy from the 12 Volt chain of the rearview mirror.

The rear digicam is waterproof which makes it capable of be displayed exterior the automobile. In complete you get a 270-degree discipline of view. Simply slide the highest half down and snap the underside half off of the windshield connector.

Set up was pretty straightforward. The sprint cam helps each entrance and rear recording. Simple approach set up sprint cam and backup digicam rearview mirror DVR system wires straightforward setup car rearview mirror DVR digicam recorder system review rear.

Flip the digicam on. Examples of Subaru vehicles which have EyeSight and sprint cams put in images beneath. The M1 has the choice of getting the mirror show in both twin or single channel view.

Your system is able to use and can mechanically begin recording. Its a decent match however it’ll slot in there. The setup ensures a complete protection of what’s taking place in entrance and behind your car.

You strap the digicam over your present mirror utilizing the supplied straps and run 3 cables alongside your higher trim to cover them. Join the opposite finish into the Mini USB Port on the rear digicam. Q1 Tips on how to use a rear view sprint cam.

These 3 cables if correctly put in can look skilled. 1Loosening the screw with butterfly nut. The very best place to mount a touch cam in a Subaru with EyeSight is sticking the sprint cam mount proper subsequent to the mount for the rear view mirror.

A DC-DC 12 Volt to five Volt converter is put in contained in the adapter which is critical to energy the Garmin 55. Upon getting purchased a touch cam it is vitally straightforward to put in and use. The wire hider for the rearview mirror comes off as properly.

The rear-lens view mechanically seems on the show display in twin Image-In-Image PiP format. Simply insert a reminiscence card connect the suction cup mounted in your windshield or the place you wish to place and plug the twine into the ability supply. As much as 15 money again The sprint cam has the performance to make use of the rear digicam as a backup digicam.

After which you can route the wires down in direction of the connector and snap the wire hider again on. 1 energy cable 1 rearview digicam cable and 1 GPS module cable. 150 from the entrance lens and 120 from the rear lens.

Join one finish of the Mini USB cable into the Mini USB Port on the sprint digicam.

Rexing M1 Simple Set up Dashcam Sprint Digicam Mirror Set up